To add a thermostat to an existing COMAP Smart Home installation or to replace a thermostat you already have, you must add it to your account by following the procedure below:
To be able to associate the thermostat with the heating module, it is necessary to put your heating module in 'pairing' mode.
In order to do so, tap quickly several times in the centre of your heating module until you see the three LEDs flash / blink.
Then, wake up the thermostat by placing your hand in the centre, after having placed it on the heating module in order to make the association: the house appears, then a double arrow, then the temperature. The module's LEDs should stop flashing / blinking.
If you have a multizone installation with several heating modules, you will need to pair the thermostat with all of your modules, ending with the one in its zone.
If you add your thermostat to an installation already equipped with a thermostat, it must be associated with a "free" module, that is not already in a zone paired with a thermostat.