In the event of an internet outage, the behaviour of your thermostat will be as follows: 

  • It will keep the last set point for 2 hours
  • Then heat to 20 degrees for 24 hours after the last capture of presence.
  • If the thermostat does not detect a presence for 24 hours, the installation will switch to freeze protection by default and regulate at 12° until a presence is detected or until the internet connection is restored. 

Without an internet connection, your thermostat works as a manual thermostat, you can change your set point in 0.5° increments. The set point remains fixed unless you make a new request on the thermostat.

If you are in a Multizone installation, the secondary zone modules will link to your thermostat zone for the duration of the communication interruption and will receive the thermostat's commands. 

Was this article helpful?

1 out of 2 found this helpful